Looper's Delight Archive Top (Search)
Date Index
Thread Index
Author Index
Looper's Delight Home
Mailing List Info

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

Re: repeater question



I'd describe Feedback Level as:
The volume level of the loop as it's fed back into the next loop.

So if I leave it at Max, the loop never dies and stays at the same volume
forever.
If I back it off, each successive occurance of the loop is quieter, until 
it
fades away.
If I take to 0, the next occurance of the loop will be silent.

Hope that helps.

Doug
----- Original Message -----
From: M. Steven Ginn <sginn@airmail.net>
To: <Loopers-Delight@loopers-delight.com>
Sent: Sunday, August 26, 2001 10:24 AM
Subject: RE: repeater question


> What is actual definition and purpose of "Feedback" and why would you
> want to control it?
>
> Steve
>
> >
> > I don't own a Repeater, so I can't address that issue.
> >
> > I have an EDP.  It may be a bit misleading to say that the
> > feedback (or as the first msg put it, "fade level") is only
> > applicable when the track is being recorded.  If I start a
> > loop and then take the EDP out of recording/overdub mode (all
> > lights green), the feedback control still applies to that loop.
> >
> > Maybe I misunderstood what you said?  Just wanted to make
> > sure that the poster had a good understanding of the EDP's
> > capabilities.
> >
> > Doug
> > ----- Original Message -----
> > From: <Hedewa7@aol.com>
> > To: <Loopers-Delight@loopers-delight.com>
> > Sent: Sunday, August 26, 2001 9:34 AM
> > Subject: Re: repeater question
> >
> >
> > > paul,
> > > >For overdubbing within a track(s), can the "feedback
> > level" (ie: fade
> > level)
> > > >be set/adjusted  independantly for each of the four tracks
> > within a
> > > >loop or is there one "feedback level" for the the loop as a whole?
> > >
> > > (somebody correct me if i's wroing (or misleading), here.....)
> > >
> > > w/repeater, a single loop is comprised of all 4 tracks.
> > > as w/the EDP, the entirety of the loop is accessed by only one
> > > feedback
> > level.
> > > however:
> > > as the feedback level is only applicable when a given track
> > is 'open',
> > > ie 'recording', and: as repeater's  'feedback level' is
> > addressed via
> > > midiCC#11, then ye can alter it at will, eg 'in between'
> > recording of
> > > the separate tracks.
> > > the unit will only record 1mono or 1stereo track in a 'pass';
> > > effectively, this means that it's possible to have
> > different feedback
> > levels
> > > for each of the four tracks.....
> > > the altered feedback level isn't applied until a track is
> > 'open'.....
> > > dt / s-c
> > >
> >
> >
>