] [Thread Prev
RE: Having Problems with controlling the levels of my looping station during performances
Will that allow me to send the guitar and vocals as a separate track to
the sound board or will I still have to control it from stage?
From: Tim Nelson [mailto:email@example.com]
Sent: Tuesday, November 23, 2004 3:48 PM
Subject: Re: Having Problems with controlling the levels of my looping
station during performances
Yep, and for even more control, run your mic into
channel 1, your guitar into channel 2, put the RC-20
in the mixer's aux send, and run the output of the
looper back into channel 3. Then with the aux send
control on each channel strip, you can control how
much of the voice or guitar goes to the looper. You'll
have a fader for voice, one for guitar and one for the
loop, and you'll be sending the house a pre-mixed line
out. Just be careful not to turn up channel 3's aux
send, or you'll get a feedback loop (or actually,
very, very carefully experiment with that feedback
loop, they can be fun!) If your mixer has more than
one aux send, you can do the same thing with another
effect, and even specify how much of one aux goes to
the other aux.
--- Aptrev@aol.com wrote:
> In a message dated 11/23/04 11:15:19 AM,
> firstname.lastname@example.org writes:
> << the only way to control the levels of the guitar
> and mike separately is
> through the looping station on stage, and the sound
> guy off stage must treat the
> guitar and mike levels as one. >>
> If I get your situation, I think I would pass the
> mic and guitar thru a small
> preamp mixer like the Eurorack mx602 (cheap!) before
> the RC20 then you can
> adjust the input of either signal.
> The Howie Day rig posted recently might give you
> some ideas:
> He uses 2 looping paths, one for voice and one for
Do you Yahoo!?
The all-new My Yahoo! - Get yours free!