] [Thread Prev
Re: The loop effect I'm wanting today: A smart replace
On Sat, Aug 14, 2010 at 9:14 PM, Mark Hamburg <firstname.lastname@example.org> wrote:
> Here is what I find myself wanting today. I don't think either the EDP
>or the Looperlative can be readily programmed to do just this. I think of
>this as being essentially smart replace.
> Tap pedal and it goes into "replace" mode. The old loop plays through
>but does so at 0% feedback so that it won't repeat again.
> One cycle later relative to the initial tap it switches automatically to
>100% overdub so that the new loop can end up seamless.
> Tap the pedal again and it stops recording but stays at 100% feedback.
> The tricky part relative to existing loopers is the automatic switch
>from 0% feedback to full feedback at the one cycle mark. If one gave up
>on the ability to tap at arbitrary times, then it might be possible to
>achieve this with a quantized sequence of operations.
> Does anyone know of something that will do this?
I gave my EDP to someone, so I can't test this in praxis, but cant you
simply put the EDP in sustained Overdub mode and - while still in
Overdub - use a SUS Substitute pedal on the cycle/loop length?
With Mobius I do it kind of like that, using SUS Substitute (with
Alternative Feedback set to "0") and this replaces everything as long
as I hold down the pedal. Then I pop directly into Overdub mode.
Greetings from Sweden
www.looproom.com internet music hub