I have one on order. Just reading specs, I'll probably
set it up much like the FCB, each switch sends note on/off
0-9 in bank 1, 10-19 in bank 2, etc.
I'm not sure how useful the pressure sensitivity will be.
The obvious candidates are the output level, feedback, and pan
controls but you usually want those to be smooth and it sounds
like that might be difficult. If we have to we could implement
some kind of controller smoothing with scripts.
Rate and pitch shift amount are other possibilities. Setting
parameters like the number of subcycles or Quantize Mode could
also be done but for those I think it's easier to cycle through
a set of values just by pressing a switch several times rather
than trying to dial one in with pressure.
We'll see...
Jeff
hey gang,
if anybody is trying this two out please let me know i have tons of questions and there arent any forums that i know of yet
plus we can start helping future users here as well
lets hook up!
cheers
Luis