D-tar solstice effects loop

[William Walker <billwalker@baymoon.com>]

Ok maybe I was a bit cranky on my last post.  I run my Fireworx  on  
the two channel inserts  of my Solstice pre amp and my LP-1 in mono on  
the master send and return,so that I can capture any of the effects  
processing on my looper, and have a master blender between the direct  
sound and the loop sound. you will need to use trs stereo to 1/4 inch  
Y cables for the inserts to connect both channels to your effect .   
Because the Fireworx is XLR, I had to have a pair of cables made. This  
routing scheme is mono so any panning effects will sound like deep  
tremolo and any stereo delays will be summed to mono. You can also run  
your stereo looper in the inserts and run your effect in the master  
effects loop if you like to do post processing of your loops,and you  
can always run the unused output from your effect and or looper direct  
to the mixer /stereo powered speakers.  There are ways to stereo-ize  
the output from your Dtar by either running in to your stereo looper  
at that point or in to your stereo effect at that point or both.
Bill