Re: Jamman footpedals

[Chuck Zwicky <chuck.zwicky@wavefront.com>]

I use a Rolls 'MIDI Wizard' with my Jam-Man setup, which in it's default
state does send 8 channels of controller data with each program change.
This does cause some lag, but was easily corrected by de-assigning the
controllers. I've experienced no oddness or switching delays since.
Perhaps this is something to look for.

-Chuck Zwicky

 
At 01:07 PM 2/23/98 -0800, you wrote:
>Is that caused by midi delay in the jamman, or the footpedal? I've used 
>the
>PMC-10 for my echoplex a bit, as well as other typical rack switching, and
>never had a delay problem. It's possible I didn't notice, since I mostly 
>use
>the dedicated pedal for the plex, but if the PMC-10 caused a delay it must
>have been pretty small. And preset switches are very quick. Are you sure
>it's not misjudgement of the throw distance to the contact point of the
>pedal? That can throw you sometimes if you're not used to the pedal. 
>
>kim
>
>
>At 12:45 PM 2/23/98 -0800, Mike Biffle wrote:
>>I have a PMC-10 midi floor controller, but for real time tapping, it
>doesn't cut
>>it. There is a slight lag. I've heard others describe tapping slightly
>early to 
>>compensate, but I'm not able to consistently do that. 
>>
>>I use the Roland 5Su's. More stable than the Lexicon stereo foot
switches, but 
>>more expensive as well. You need two for each stereo input on the 
>JamMan. I
>use 
>>a stereo channel insert cable to attach each pair.
>>
>>-Miko
>>
>>>I have a Ground Control footswitch I use on mine and it works fine. 
>>>Can't say I have taken it out a whole lot.
>>>Trevor
>>
>>
>>
>>
>_______________________________________________________
>Kim Flint                      408-752-9284
>Mpact Systems Engineering      kflint@chromatic.com
>Chromatic Research             http://www.chromatic.com
>
>
>
>