Re: PEDAL BOARDS and an OT Velcro glue substitute request

[Mike Feeney <feeneymike@yahoo.com>]

    staple gun and spray-on adhesive....  That's what I'm planning on using
anyway.  =)

    that aeroson adhesive in a can would stick the wheels of your car to 
the
road if you let it, I'm convinced.  =)

    the staples would basically serve to hold the item in place while the
adhesive dries, then would serve as supplemental support.

    mike



on 7/9/01 1.02 PM, John McIntyre at mcintyre@pa.msu.edu wrote:

> OK, I use the self-adhesive velcro all the time.  Not just for my pedal
> boards,
> but for household repairs as well.
> 
> And I keep running into the same problem: the velcro - velcro bond is 
>stronger
> than the bond between the adhesive and whatever I'm trying to mount the 
>velcro
> on.  The result is that when I try to remove the top item, the velcro 
>stays
> bonded together, and the lower layer of velcro is pulled off whatever it 
>was
> mounted on.
> 
> Any suggestions?
> 
> John McIntyre
> Physics - Astronomy Domine Dept
> Michigan State University
> mcintyre@pa.msu.edu


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com