[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: Loopers-Delight-d Digest V01 #404
my $.02:
if you are handy with a soldering iron you can go to radio shack (or
order thru allied or somesuch) a d-sub housing (male & female, of
course) and wire up your own multipin connector. i did it to wire
up 6 effects from different maufact's into one pedalboard (a
cannibalized $20 mesa boogie thing); but you can use the same principle
for a number of things.
you do have to be a LITTLE careful, but the d-sub (which gives you, what,
i think 26 or 7 points?) is not too impossibly tiny to work with - not
nearly as pad bad as the points on a TT bay, frinstance....
just a idea.... hope this isn't off the point!
rbrt
Hi MArk-
I was looking into this a few months ago, since I have a similar
situation. Whirlwind has nice multipin connectors available, but
they're difficult to assemble. When I looked at having them make
custom fanouts on multipin connectors, it was going to cost upwards of
$1000. I believe ProCo also sells a multipin connector. A
56-pin Elco connector would also work for you, and you can probably buy
them with the multicore already connected at the connector end.
I had two stereo, eight audio, and one MIDI cable to connect to my rack,
aside from all of the interconnections. I'm really lazy and I
already spent all of my money on gear and cables, so here's what I
did: I assembled all of my drum machines and synthesizers together
on a folding table with their power hooked up to a power strip and their
syncs and other interconnections made, like a pedalboard. Then I
hooked up individual cables from the various machines to the back of my
rack, labeled them at the rack end, and wire tied all of the cables
together into a loom. So when I break down, I just pull all of the
plugs out of the back of the rack and put the loom on the table with the
other gear for transport. This allows me to connect everything in
about a minute, whereas it took more than twenty before, and it's not
such a rat's nest anymore. I'm glad I did it this way, because I
find myself creating a new routing paradigm before every gig, and the
loom makes it easy to reconfigure.
-Hans
On another issue: I have been
thinking of making a big fat multicore cable
to connect my rack of er... stuff to all the misc pedals on the floor
(a
good 20 minutes it take to plug in at soundcheck, by which time...
there
isnt any!!!) Has anyone done this and found a good connector. It need
to
take 6 audio/2midi/and various (8) stereo cable pedals (like the
vortex
ones). I'm thinking of a big old metal box on the rack and a big old
metal
box on the floorboard... could I use a mixing desk multicore
cable....
Just wanted other peoples solutions... (When is stuff gonna be
wireless???)
MArk Francombe Red
--
Hans Lindauer
Engineer, Music Man R&D
Ernie Ball, Inc.
just what the world needs....