[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

RE: repeater question



Thanks!

> -----Original Message-----
> From: Doug Cox [mailto:bickleypunk@pdq.net] 
> Sent: Sunday, August 26, 2001 8:53 AM
> To: Loopers-Delight@loopers-delight.com
> Subject: Re: repeater question
> 
> 
> I'd describe Feedback Level as:
> The volume level of the loop as it's fed back into the next loop.
> 
> So if I leave it at Max, the loop never dies and stays at the 
> same volume forever. If I back it off, each successive 
> occurance of the loop is quieter, until it fades away. If I 
> take to 0, the next occurance of the loop will be silent.
> 
> Hope that helps.
> 
> Doug
> ----- Original Message -----
> From: M. Steven Ginn <sginn@airmail.net>
> To: <Loopers-Delight@loopers-delight.com>
> Sent: Sunday, August 26, 2001 10:24 AM
> Subject: RE: repeater question
> 
> 
> > What is actual definition and purpose of "Feedback" and why 
> would you 
> > want to control it?
> >
> > Steve
> >
> > >
> > > I don't own a Repeater, so I can't address that issue.
> > >
> > > I have an EDP.  It may be a bit misleading to say that 
> the feedback 
> > > (or as the first msg put it, "fade level") is only 
> applicable when 
> > > the track is being recorded.  If I start a loop and then take the 
> > > EDP out of recording/overdub mode (all lights green), the 
> feedback 
> > > control still applies to that loop.
> > >
> > > Maybe I misunderstood what you said?  Just wanted to make 
> sure that 
> > > the poster had a good understanding of the EDP's capabilities.
> > >
> > > Doug
> > > ----- Original Message -----
> > > From: <Hedewa7@aol.com>
> > > To: <Loopers-Delight@loopers-delight.com>
> > > Sent: Sunday, August 26, 2001 9:34 AM
> > > Subject: Re: repeater question
> > >
> > >
> > > > paul,
> > > > >For overdubbing within a track(s), can the "feedback
> > > level" (ie: fade
> > > level)
> > > > >be set/adjusted  independantly for each of the four tracks
> > > within a
> > > > >loop or is there one "feedback level" for the the loop as a 
> > > > >whole?
> > > >
> > > > (somebody correct me if i's wroing (or misleading), here.....)
> > > >
> > > > w/repeater, a single loop is comprised of all 4 tracks. 
> as w/the 
> > > > EDP, the entirety of the loop is accessed by only one feedback
> > > level.
> > > > however:
> > > > as the feedback level is only applicable when a given track
> > > is 'open',
> > > > ie 'recording', and: as repeater's  'feedback level' is
> > > addressed via
> > > > midiCC#11, then ye can alter it at will, eg 'in between'
> > > recording of
> > > > the separate tracks.
> > > > the unit will only record 1mono or 1stereo track in a 'pass'; 
> > > > effectively, this means that it's possible to have
> > > different feedback
> > > levels
> > > > for each of the four tracks.....
> > > > the altered feedback level isn't applied until a track is
> > > 'open'.....
> > > > dt / s-c
> > > >
> > >
> > >
> >
> 
>