[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

RE: PMC10 problem



Thanks Ed, but I have already changed the battery. (I went ahead and
sent the file to Sean)

Thanks,
Steve

> 
> Steve,
> 
> The only other thing I can think of is to change the battery 
> inside the footpedal that stores the memory.  It is a 4.5 
> volt battery a little bigger than a AA size.  I was having 
> some memory corruption issues and changing the battery fixed 
> everything.
> 
> 
> Ed
> 
> 
> >Hi Ed,
> >
> >Well my original configuration had the PMC10 set on channels 
> 15 & 16. 
> >After it went through its initial reset, it would no longer 
> communicate 
> >so I had to use the handheld controller to change the midi channels 
> >back to what I had originally programmed.  I then tried the upload 
> >again and the PMC10 was able to respond to the data, but ultimately 
> >ended up like before doing a full reset back to factory 
> defaults.  It 
> >is almost as if it gets all the data and then locks up (with 
> all lights 
> >on) providing a reset (to default) as the only option to get 
> the unit 
> >working again.
> >
> >Steve
> >
> >
> >>
> >> Steve,
> >>
> >> I ran into this recently. It might be because because in 
> the factory 
> >> reset state NONE is the channel selected for the PMC 10.  On page 
> >> 3-11 of my PMC 10 Owner's Manual it says "The PMC10 will only 
> >> transmit and receive PMC10 SysEx data when PMC10 Channel 
> is 1-16." Go 
> >> to submenu of MIDI and set PMC Channel to 1-16.  Hopefully 
> that's all 
> >> that it is.
> >>
> >> Ed
> >>
> >>
> >> >
> >> >Hi Sean (or any LD PMC10 owner),
> >> >
> >> >
> >> >I performed a download of my PMC10 using Raymond and then 
> saved the 
> >> >file on my PC.  Everything seemed like it was working just
> >> fine.  Then
> >> >for some reason, I accidently did an upload of the current saved 
> >> >document, however the PMC10 reacted by flashing its display
> >> erratcially
> >> >and then ending with a message in the display stating to
> >> press enter to
> >> >reset.  Low and behold, the system was reset back to factory
> >> defaults
> >> >and now I can't seem to restore the saved document that I
> >> created using
> >> >Raymond.  Any ideas would be very helpful  & I would rather
> >> not have to
> >> >manually set everything back up (82 patches, 12 banks,
> >> etc.).  My midi
> >> >connections appear to be working properly, just for some 
> reason when 
> >> >Raymond says that it is transferring data, the PMC10 doesn't
> >> seem to be
> >> >putting it where it needs to be.
> >> >
> >> >
> >> >Thanks,
> >> >Steve
> >> >
> >> >
> >>
> >>
> >>
> >>
> 
> 
> 
>