[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
EDP question
Hello-
My EDP is acting strange tonight and I am wondering if any of you have
experienced similar behavior and can offer any suggestions. It currently
resides in a 3sp rack with a TC M-One below and a JamMan above- after being
on for a few hours and not being used at all I looked and it was repeating
the start display sequence over and over- (it was obviously just trying to
bring attention to my overt neglect) - after powering it down numerous
times
it would stop responding with 5.0 in the display- it is luke warm to the
touch and has seen hotter conditions so I'm doubtful heat is the culprit-
maybe I should remove the RAM and clean it? Thanks in advance-
Cliff
PS- I just turned around and saw it scrolling the Loop 3.0 again then
stopped on 5.0- is this the EDP's way of sticking it's tounge at me behind
my back? :)