Re: Vortex Repair

[Miko Biffle <biffoz@pacbell.net>]

Hey Cliff,

I did the same thing... installed the rotary encoder myself and still 
didn't
work. So I sent it off to Lexicon for their flat-rate repair of (I believe)
$95. Worked great from then on. The invoice showed that they cut a trace 
and
jumpered something as well as replacing both encoders. -Miko

----- Original Message -----
From: Clifford@BienAppraisers <res0koq3@verizon.net>
To: <Loopers-Delight@loopers-delight.com>
Sent: Thursday, January 31, 2002 2:36 PM
Subject: Vortex Repair


> I ordered a replacement pot for the parameters on my Vortex- I tried to
> replace one before without success- I'm decent with soldering skills but
> this was difficult- it looked perfect but was not working- I'd like to 
>try
> it again on this new one- any suggestions or tips for the procedure
> appreciated.
>
> Cliff
>
>