[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: EDP - Sync With Cubase Problem - Strange
in addition to what some others suggested, you might try:
- make sure the feedback knob (or pedal) is not accidently turned down to
0%.
- make sure that cubase isn't sending the MIDI continuous controller for
feedback and accidently setting it to 0%.
- check the SamplerStyle parameter is set to the default value of "run".
If
it were on Once or Attack it might do what you are describing.
kim
At 04:42 AM 8/8/2002, Michael Clark wrote:
>I start Cubase (midi clock) and can see the EDP light each time on the
>downbeat. I press record just before I want to record a loop so that the
>EDP begins on the correct downbeat. It does. I hit record to stop the
>unit just before the end of a bar so the EDP records the number of bars I
>want for the loop. It does. The problem is that what I have recorded
>into
>the loop either plays once or not at all. I tried leaving the loop open
>(no sound) and using overdub to layer loops. The loops in Overdub don't
>seem to record. Feedback is all the way up. The unit is getting good
>signal.
>
>BTW, during the initial recording process, and the subsequent overdubbing
>process, Cubase is still running - sending MC.
>
>At on point, I stopped Cubase and the loop played to the end and stopped.
>
>Any ideas as to how I might get the loops to play as they usually do when
>I'm not syncing?
______________________________________________________________________
Kim Flint | Looper's Delight
kflint@loopers-delight.com | http://www.loopers-delight.com