[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
FCB1010 question
Hello,
As some of you may recall, I sent a message a few days back saying how
I, a complete midiot, had no need for a sysex file for the FCB 1010
since I had figured out how to program it all by myself. Or so I
thought (I grasp the theory at least). What I discovered last night is
that I don't seem to be able to program the expression pedals properly
at all. I'm using this to control the Repeater (or trying to) btw. Now
the problem is this, I go into programming mode, choose the expression
pedal, select the controller number I want to send and then enter the
range 0-127 or 40-75, etc). Now this is all well and good until I try
and actually use the pedal and then I find that is sending all kinds of
commands to the repeater (multiply by 2, reverse, record select, start,
loop select up and down). It runs through all of these when I move the
pedal up or down. Do it fast enough and it will freeze the Repeater (I
actually had it come up with the screen multiply by 1 (?!) and then it
locked up).
After a little experimentation, it seems that the expression pedals
primarily run the repeater through the loops (1' to 64 and back). Move
the pedal fast enough and then I can get the other commands (record,
reverse, mult by 2, etc). It really doesn't seem to matter what values
I program in for the pedal (I can turn them on or off in a preset, but
nothing else seems to stick).
So, anyone know what I'm missing or have any idea of why this might be?
Thanks
Kevin
--
Wonderful! Wonderful!
The sermon of the inanimate is inconceivable
If you try to hear it with your ears
You'll hardly understand
Only when you hear it in your eyes
Will you be able to know.
- Dongshan Liangjie