[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: SwitchQuant parameter
The helps. Thanks, Cara.
jeff
On 4/15/03 19:52, "Goddess" <thefates@earthlink.net> wrote:
> Jeff, In Loop IV, there are six settings for SwitchQuant.
>
> Off, Confirm, cyc, ccy, loop, and clp. <smile> -Sorry about my
>incorrect
> abbreviations in some cases. -Hopefully someone here will correct these
> if need be.
> Cyc, or cycle, switches between loops at cycle boundries. If the cycle
> happens to be the entire loop, then it will switch at the loop point. If
> the cycle is half of a loop, then that will be the point where the switch
> takes place. Does this make sense?
> Which software are you using? I'm assuming these options are different
> between Loop III and Loop Iv, so perhaps someone else may be able to
>better
> assist you. <smile> -Hope this helps...
>
> Smiles,
>
> Cara
>
> At 03:15 PM 4/15/03 -0400, you wrote:
>> I've been finding Jesus in the EDP manual over the past couple of days.
>>
>> One setting that I am pleased with but unable to diagnose is the
>following:
>>
>> SwitchQuant=Cyc
>>
>> In the PDF version of the manual I'm reading
>> (http://www.randomsalt.com/find/howto/Echoplex_Manual.pdf ) there is no
>> reference that I am able to find to this setting. Only "On", "Off", or
>> "Confirm".
>>
>> Is it reasonable for me to think that cyc=on?
>>
>>
>>
>> Jeff
>> http://www.randomsalt.com/music/edp.conf
>>
>>
>
>
> ---
>
> "The only things I really think are important, are love, and eachother.
> -Then, anything is possible..."
>
> http://home.earthlink.net/~thefates
>
> Please visit BadFiction and The Guitar Cafe.
>
> http://groups.yahoo.com/group/badfiction
>
> http://groups.yahoo.com/group/the-guitar-cafe
>
>
>