[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: Volume pedals
----- Original Message -----
From: "armatronix" <armatronix@charter.net>
> Well, one thing about Ernie Ball pedals is that they are made in the
> U.S.A., by workers who earn a living wage. The other thing is, they are
> built to last forever. The pots and strings wear out eventually, but
>they
> are completely renewable. Third, they are built with an extremely high
> quality specification which dictates a lot of careful handling. Look
> closely at all of the the beveled edges - they're done by hand with a
> file. Now, all of this is not necessary, but the boss believes that it
was
> the right way to do things, and I tend to agree for the most part (even
>if
> it is somewhat over-engineered). When you figure in materials cost,
> machining, labor, and packaging, the Ball family is probably not making a
> lot of money (if any) off of a volume pedal. But they sell a lot of
> strings, so it enables them to make high-quality guitars and volume
>pedals
> for a reasonable price.
The last one I had had a scratchy pot after about 8 months of
use. What a POS. No amount of tuner lube could clean it up
because there was no way to spray it into the pot.
I now own a Morley volume pedal. I'd rather not depend on crap
for critical applications.
> Very soon, you will start seeing a smaller version of the EB volume pedal
> hit the shelves, which I personally re-engineered to save aluminum
>without
> sacrificing durability. It's smaller and somewhat less clunky, and much
> lighter, but essentially the same design. It's being made in Malaysia I
> believe, so I hope it will be significantly less expensive than the
regular VP.
Yep. Screw those American workers. Something to be damm proud of.
* David Beardsley
* microtonal guitar
* http://biink.com/db