Re: repeater midi clock

["Nic Roozeboom" <nic_roozeboom@msn.com>]

I see this also, but by all evidence only as a read-out discrepancy, not 
as 
a real timing inaccuracy. I can have a sequencer at 120, the readout might 
say 120.0 or 120.1 but after letting the loop run for many many times 
(30mins?), there will be no discernible shift (of course). It might be 
that 
due to the adaptability/tracking (rather than hard lock) that the Repeater 
offers, the readout is a result of a longer-term running average 
calculation 
- combined with a rounding artefact. Someone with knowledge of the 
algorithm 
could tell, but those souls apparently don't roam this forum anymore (or 
do 
they?).

Nic


>From: Paul Greenstein <paul@ubiq.co.uk>
>Reply-To: Loopers-Delight@loopers-delight.com
>To: Loopers-Delight@loopers-delight.com
>Subject: repeater midi clock
>Date: Mon, 20 Oct 2003 10:12:02 +0100
>
>Has anyone else encountered minor inaccuracies when MIDI clocking a 
>Repeater from a sequencer? I'm using Logic 6.2. For example, I set 
>Logic's 
>tempo to 120 bpm, the Repeater thinks a bit, agrees, but then finally 
>settles on 120.1...
>I don't see it as a major problem, but is does seem slightly strange.
>
>
>
>Paul Greenstein
>

_________________________________________________________________
Surf and talk on the phone at the same time with broadband Internet 
access. 
Get high-speed for as low as $29.95/month (depending on the local service 
providers in your area).  https://broadband.msn.com