|
Well that’s what I just reported. It
doesn’t match automatically unless they both START at the same setting. Incrementing
a param on the master increments on the slave but doesn’t match it
automatically. Unless I was hallucinating, or I have a deviant 2nd EDP,
that’s what I’ve seen on mine. Seems that saving/recalling a preset on
EDP slave that matches the master is the best way to insure they’re set
for perfect stereo operation. if i recall correctly (and there's a good chance i don't), you can connect
them via midi and set the params on the master, which will in turn select them
in the slave. for example, if you're in param X and slave differs from
master, then you can adjust slave to match and continue on with the
programming. -jim |