|
I hear you, I have already done this. I
use 5 banks in my PMC set for one EDP and duplicated them for the second EDP. I was hoping to finess this using a few
banks to control both, with a couple patches to switch from stereo to dual
mono. I think Sysex is what’s going to do
this. A different ID # on each EDP What is the sysex string that I’d
need to put into the PMC to switch channels back and forth? Say changing from Ch 6 to 7 Then changing back from 7 to 6 Neil -----Original Message----- "There's
gotta be a simple workaround, that could change from dual mono to stereo via
midi without touching the EDP." there
is...and it all has to do with the foot controller. set each to a
different channel, say 1 and 2. program your controller to send identical
messages on 1 and 2 simultaneously. edp1 will accept ch. 1 messages and
pass ch. 2 (i think...if not, split your midi cable to both units.) this
will allow for stereo operation. do the same, but have the presets for
edp1 and edp2 seperately. now they should function fairly independently. this is
all just in my head though...never actually tried it, so it may not work. -jim |