Re: Oh no....more FCB1010 questions

["Dave Sturt" <dave@davesturt.f9.co.uk>]

Hi - sounds to me like you need to calibrate your pedals - I had the same
problem.
This info is from the very useful Yahoo FCB1010 user group.
Hope it helps.

Dave Sturt
----------------------------------------------
1. Keep footswitches 1 and 3 pressed while switching on the unit (This bit
you can't

do standing up!). Release the switches when the display blanks. The LEDs on
the

footswitches, the ones on the display and each segment of the two numeric

displays will turn on and off in sequence.

2. Wait until all footswitch LEDs are on. Depress all footswitches one at a
time,

including UP and DOWN, until all LEDs are off.

3. Wait until relay switch test is finished. (There will be a couple of
mechanical

clicks, and the display will end up reading "F1" (at least, it did on
mine)). [Also, if

you have connected a MIDI cable between the MIDI in and out, the display
will

show "A1" before this, meaning the midi ports work correctly.]

4. Press DOWN once.

5. Adjust the left expression pedal (A) to the lowest value. Once adjusted
press UP.

6. Adjust the left expression pedal (A) to the highest value. Once adjusted
press UP.

7. Adjust the right expression pedal (B) to the lowest value. Once adjusted
press UP.

8. Adjust the right expression pedal (B) to the highest value. Once 
adjusted
press

UP.

9. Select a patch which has both pedals set to their full range, and check
the

expression pedals now send 0-127 (0x00-0x7F)

----- Original Message ----- 
From: "lol c" <testtubemicro@hotmail.com>
To: <Loopers-Delight@loopers-delight.com>
Sent: Wednesday, February 25, 2004 3:32 PM
Subject: Oh no....more FCB1010 questions


> Hi all
>
> I know how often this stuff comes up on list and belive me i have tried
for
> the last week to NOT post to list for help. but Ive reached the stage
where
> I cant complete my tailor made midi board just becaus of one problem...
>
> Basically I cant get the controller pedals to respond.
>
> Im using Loop4 and Midi FCB1010.
>
> Ive got the "patches" set up so that I have record,overdub,
multiply,insert,
> replace, undo, speed, drection, substitute, and next in that order on
patch
> bay one, then the same but in suspend mode on page two, then a few 
>presets
> stored in page three......ok so far so good.
>
> now on each of these presets I have the buttons of each controller lit 
>and
> active and set to 7 for feedback and 1 for Volume.
>
> on the echoplex I have  the buttons in the perameters corrispondinf to
> feedback and volume set to 7 and one respectivly, yet.........nothing.
>
> I can move the continuos controller pedals back and forth and the reout 
>on
> the screen never changes to display a new feedback or volume setting
>
> whats going on?
>
> Help me please
>
> Phill Wilson
>
> _________________________________________________________________
> Express yourself with cool new emoticons
http://www.msn.co.uk/specials/myemo
>