[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

Re: EDP Sync with MPC 1000



I'm having a similar problem. My EDP is synced to an Alesis drum machine
with MIDI clock, and my SWITCHQUANT parameter is set to LOOP. It will move
from the first loop to the second flawlessly. When I go back from the 
second
to the first, however, the second loop restarts then changes back to the
first after a few beats. This throws the time out.
Someone responded to my post and said I should make sure the drum machine
and EDP were set to different MIDI channels, otherwise the drum machine
could also be sending note messages.
As soon as I figure out what that means I'll try it.
Maybe it applies to your problem.
Good luck



----- Original Message ----- 
From: "John Metzler" <jarofjam@mac.com>
To: "Loopers Delight" <Loopers-Delight@loopers-delight.com>
Sent: Friday, April 23, 2004 10:47 PM
Subject: EDP Sync with MPC 1000


> I have my EchoPlex synced to my MPC 1000 with beat clock.  It stays
> locked if I just record one loop and leave it at that.  But what fun is
> that? if I copy that loop to a second loop to add material and then
> switch back to the first loop,   it has strayed.  The beat clock light
> in the bottom right still shows the accurate pulses from the MPC 1000
> but the loop is off as well as the Flashing light that indicates the
> loops beginning.    Any suggestions?  I can't perform live with this
> set up if this is as reliable as it gets.
>
>