[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: OT: Fuzz
On Jun 7, 2004, at 10:19 AM, Greg House wrote:
>
> Thanks for the review. I played a Vox modelling combo amp awhile back
> and was
> very impressed.
>
> What features does the looper have?
It's really basic. This is from the manual:
10. HOLD DELAY (HOLD DLY) MONO IN/MONO OUT 1
If you assign “HOLD DLY” to the CONTROL pedal, you’ll be able to hold
the delay
sound.
[1] “TIME” 1–8000 [ms] Sets the delay time.
[2] “FEEDBACK” 0.0–10.0 * Adjusts the amount of feedback.
[3] “TONE” 1.0–10.0 * Adjusts the tone of the delay sound.
[6] “MIX” 0.0–10.0 * Adjusts the mix amount of the delay sound.
CONTROL pedal: HOLD DLY: If you select “HOLD DLY” for the CONTROL
pedal, the delay sound will be held from the
moment you turn the pedal on.
>
>> One weird thing about it is when I got it it was set to "amp" out
>> (expecting to see a guitar amp) so I switched it to "Line" for my
>> mixer. I had this ugly high end on a lot of the patches I couldn't
>> seem to dial out.
> I'm confused. Are you saying it sounds better plugged into your mixer
> using the
> "Amp" setting? Or the "Line" setting with the settings tweeked?
Oh, it's confusing. I am saying that I set the Tonelab to it's AMP
mode for output, but I do not run it through a guitar amp, as is
prescribed in the manual. Why it's amp output is lacking high end
compared to it's line output is beyond me. Doesn't make sense right?
A guitar's output is thin and tinny. An amp pre puts in that needed
bass and midrange that a guitar's output lacks. Why would you do that
if you thought the signal was going into an amp? That's like filtering
something and then filtering it again.
>
> Excellent! Sounds promising!
>
> Greg
I'll try to get to recording it tonight and I'll post the results.
Mark