|
Well, it only took about three weeks but it has finally arrived.
Hurray!
I spent all of 5 minutes with it so far and can see that there is a lot of
potential. However, I'm STILL wondering if my money wouldn't have been better
spent on the Boss Loop Station.
The first hurdle that I need to overcome is where in my signal chain will I
put this thing.
I'm a multi keyboardist so this IS a poser.
My initial impulse was to put it after my line mixer and before my amp. In
theory that's a fine idea, except that it means that everything I do is
potentially going to get recorded in my loop. Rather than "build" my
performances from a loop upward, I want to make loops while I'm grooving.
Therefore capturing everything is NOT a good idea.
I could select a single keyboard and put the DD-20 between this board and
my line mixer. But that seems really limiting.
Ultimately, I may have to incorporate a submixer before the delay. Then I
can mute channels that I don't want to record to the DD-20.
That sounds like a lot of work and expense!
What do you veterans have to offer in the form of advice?
Thanks,
Carl
|