[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Troubleshooting my EDPs and FCB....Again (factory reset guidance)
Speaking of which, I just can't get my FCB to work with my EDPs linked
in stereo. Both EDP units A (primary or first in the signal/MIDI chain)
and B are linked via Brother sync and MIDI. I record a four measure
loop, and hit Record again to play it back...but what happens is that
only the B EDP unit is playing the loop back, not unit A. I can see the
Feedback LED light up on the B unit, but not the A unit. The FCB
appears to be sending some other signals besides the standard Note data
to trigger the basic EDP functions, and making changes to one of the
EDP's parameters. When I reset both EDPs to have the same parameters,
and then switch them around, the same thing happens, but with different
units...so it's not a defective EDP. And both units work perfect with
my Gibson Echoplex controller.
Before I start troubleshooting in detail, I thought I would try
resetting the FCB to factory state first. However, I am confused by what
the manual says about this. It shows three ways to perform a factory
reset: V-AMP family products, BEHRINGER guitar amps, and BASS V-AMP
product range. Is there a particular reset option I should choose?
Once I reset, I'll go back and re-program the switches to send the
correct notes to the EDPs to trigger the functions I want. Then if the
problem persists, I'll start troubleshooting in detail in later today.
I really want to get this FCB working with the EDPs. It would be nice
to tap into all those other features like half-speed, which I can't
access with the Echoplex controller.
Kris
> Someone in the Bay Area, please go buy these guys EDPs and FCBs!!!
;-)
Greetings from Sweden
Per Boysen
www.looproom.com (international)
www.boysen.se (Swedish)
---> iTunes Music Store (digital)
www.cdbaby.com/perboysen