[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: 2nd EDP+ for stereo
Hey Kris,
Can u tell me how to quickly dump all the presets from
the master EDP to the slave?
thanx
Luis
--- Kris Hartung <khartung@cableone.net> wrote:
> I use two EDPs in true stereo. We've had this
> discussion before on the list,
> and playing in stereo is less important to some than
> others, but for me it
> is essential to my "current" sound, given all the
> stereo imaging I use with
> my laptop VST effects. I'm also an addict of lush
> stereo chorus and stereo
> delay where the left side is lightly longer than the
> right.
>
> In any event, I have had no troubles with my setup,
> except initially when
> trying to figure out how to get the two EDPs to sync
> up and prevent signal
> drift. When you get to that point, send me an email
> and I'll send you the
> list of parameters.
>
> I run from my into my Boss VF1 from my guitar, out
> of the VF1 in stereo,
> into my laptop in stereo, out of the laptop in
> stereo, into my Mackie mixer
> board (two channels panned left and right), and then
> I run out of the
> mixer's BUSS 1 into the input of one EDP, and out of
> BUSS 2 into the input
> of the other EDP....then out of the two EDPs into
> two channels of the board,
> panned left and right. This way, when multiple
> people or instruments are
> plugged into my board, I can simply press the buss
> 1/2 button on their
> channel and loop them in my mix. I run an Lexicon
> LXP1 in my mixer's AUX 1
> channel, and back into a stereo channel of the board
> for a nice reverb on
> everything.
>
> I think the results are especially noticeable and
> fun when you are recording
> off the board....then the stereo imaging really pops
> out, if you are using
> effects that to tricks in stereo.
>
> Kris
>
> ----- Original Message -----
> From: "Dennis Montgomery" <morpheus@speakeasy.net>
> To: <Loopers-Delight@loopers-delight.com>
> Sent: Thursday, January 12, 2006 6:58 PM
> Subject: 2nd EDP+ for stereo
>
>
> > Hi all, I currently take the output from my lone
> EDP+ and send it through
> > an Alesis Microverb III to get some pseudo-stereo
> separation. I'm
> > considering adding a 2nd EDP+ so I can process my
> loops in true stereo. I
> > was wondering if any players who have taken this
> step can comment on their
> > experience of using a 2 EDP+ stereo system? Did
> it really make a
> > difference in your playing fun? Any technical
> problems? etc...
> >
> > Dennis
> >
> >
>
>
>
www.luis-angulo.com
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com