Re: moebius questions

["Tilmann Dehnhard" <tilmann@dehnhard.com>]

thanx a lot for the advice. very helpful!

so the magic word number one is "quantize"...

and magic word number two is obviously "toggle", but i haven't found the 
place yet where i could set it.

yes, i meant tracks instead of loops.
and thanx for the rate shift - idea!

best - tilmann

----- Original Message ----- 
From: "Rainer Thelonius Balthasar Straschill" <rs@moinlabs.de>
To: <Loopers-Delight@loopers-delight.com>
Sent: Sunday, July 13, 2008 12:35 AM
Subject: AW: moebius questions


>> i have two moebius-questions, might be a bit newbie-ish:
>
> First of all, great information sources for Mobius users are:
> * Mobius manual (available at the Mobius site)
> * EDP LoopIII and LoopIV manuals
> * Mobius discussion group
>
> All of your questions are answered in those manuals.
>
>> how do i program "half speed" to switch right at the trigger moment,
> and not after finishing the cycle?
>
> Set quantize to off for the respective track
>
>> how could that same button toggle between "half speed" and "normal
> speed"?
>
> I don't understand that question - this is the definition of "toggle", to
> alter between two states, right?
>
>> is there a corresponding command for "double speed"?
>
> Yes and no. The EDP does not have a double speed function, on the EDP, 
>the
> only way to get double speed is to record at half speed then switch to
> normal speed. With Mobius, you can simply use a RateShift=+12. Both
> RateShift and HalfSpeed work independently.
>
>> i would like to have loop 1 and 2 run synchronous, loop 3 and 4
> independently.
>> (right now all of them run independently). where and how do i set
> such a default?
>
> I assume you refer to tracks 1 to 4 here, right? (Loops are the different
> loops on one track between which you switch but which never sound at the
> same time).
> Set track1 and track2 to Sync=Out and leave tracks 3 and 4 in sync=off.
>
> Rainer
>