On Aug 21, 2011, at 10:42 PM, Mark Hamburg wrote:
I was always a bit frustrated on the EDP that you could only copy into
another loop if it was empty.
I've been copying into non-empty loops by setting Quantize = Loop or
Cycle, and SwitchQuant = CNF. Then I can press NextLoop, and at my leisure
press Multiply. Then regardless of the next loop's content, at the next
quantized point it starts to lay in the current loop's cycles until you
tell it to stop.
I'd like that to be easier - as you would too I imagine :D But it works :)
Phil :)