Looper's Delight Archive Top (Search)
Date Index
Thread Index
Author Index
Looper's Delight Home
Mailing List Info
[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

Re: PMC10 problem

Steve,

I ran into this recently. It might be because because in the factory reset
state NONE is the channel selected for the PMC 10.  On page 3-11 of my PMC
10 Owner's Manual it says "The PMC10 will only transmit and receive PMC10
SysEx data when PMC10 Channel is 1-16." Go to submenu of MIDI and set PMC
Channel to 1-16.  Hopefully that's all that it is.

Ed


>
>Hi Sean (or any LD PMC10 owner),
>
>
>I performed a download of my PMC10 using Raymond and then saved the file
>on my PC.  Everything seemed like it was working just fine.  Then for some
>reason, I accidently did an upload of the current saved document, however
>the PMC10 reacted by flashing its display erratcially and then ending with
>a message in the display stating to press enter to reset.  Low and behold,
>the system was reset back to factory defaults and now I can't seem to
>restore the saved document that I created using Raymond.  Any ideas would
>be very helpful  & I would rather not have to manually set everything back
>up (82 patches, 12 banks, etc.).  My midi connections appear to be working
>properly, just for some reason when Raymond says that it is transferring
>data, the PMC10 doesn't seem to be putting it where it needs to be.
>
>
>Thanks,
>Steve
>
>