Support
Looper's Delight
|
Support |
|
|
Thanks Kim, yup I get the feeling that the Rolls just isn't going to cut it in the long run. I have been debating on whether to purchase a Yamaha MFC-10 rr a Mitigator RFC-1 (If I can find one). I know the MFC-10 send one CC value when a switch is pressed and another when a switch is released but can the Mitigator do that? Thanks Kevin McPeak -----Original Message----- From: Kim Flint [mailto:kflint@loopers-delight.com] Sent: Tuesday, February 26, 2002 12:58 PM To: Loopers-Delight@loopers-delight.com Subject: Re: Muting Repeater & Echoplex Simultaneously At 08:26 AM 2/26/2002, plain jane wrote: >My thought is to control the Echoplex by midi and to send it control or >program changes through the the echoplex doesn't use program changes to control its functions, so make sure you are not sending those to it. It uses either note on/off or continuous controllers. >I ve also tried just hooking the midi wizard straight to the echoplex to >get it to mute via a control change. No luck there either, so I m doing >something wrong with the midi controls, any help is greatly appreciated. make sure you have midi channel set right, and the echoplex ControlSource parameter set to use continuous controllers. >I have tested the midi wizard as well and it send control changes fine to >the Repeater so it isn t the problem. it could be. I don't know the rolls pedal well, but I always thought it was lacking in some way such that it didn't work with the echoplex. What you'll want is for it to send a continuous controller with some value when you press a switch down, and when you release the switch it should send the same controller with value 0. If it can't do that, then you may want to consider investing in a better pedal than the rolls. kim ______________________________________________________________________ Kim Flint | Looper's Delight kflint@loopers-delight.com | http://www.loopers-delight.com