Support
Looper's Delight
|
Support |
|
|
I tried that, I isolated it from midi but it still did the same thing. That made me really worried... thanks for your help Kim! kevin ----- Original Message ----- From: "Kim Flint" <kflint@loopers-delight.com> To: <Loopers-Delight@loopers-delight.com> Sent: Monday, July 22, 2002 5:14 PM Subject: Re: EDP Problem > Does it work if you disconnect it from MIDI? Sounds to me like you might > have a midi loop somehow. > > At 06:00 PM 7/22/2002, Brother Sean wrote: > >I have an EDP with Loop IV. I installed the software about a month ago and > >everything was working fine but just over the weekend I have had some > >troubles. When I intially power up the EDP will cycle through its LOOP 4 > >screen two to three times before allowing me to enter the actually looping > >screen (for lack of a better term the screen where your loop time appears). > > we usually call that "reset" when you haven't recorded any loop yet. Or >we > call it the "play state" or "play mode." > > >It used to never take that long just one cycle through. > > I'm not sure if I understood exactly what you are seeing, but normally >the > "Loop 4" zips by on the display 3 times at boot up, then stops and steps > off the display, then shows the version, and goes to the reset state. Are > you saying that it is repeating all of this sequence several times? If it > is repeatedly rebooting itself at power up, there may be some hardware > problem. It could be something simple, like the memory or rom sockets got > dirty or a little corroded. Reseating the roms and the memory might clear > it up. > > >Also when I press the parameter button in order to modify the settings >it > >won't let me cycle through Timing, Keys, Midi and Loops. It usually gets > >stuck bouncing between Timing and Keys (with each press of the Parameter > >button) and will rarely cycle all the way through allowing me to get >back to > >the "actual loop screen". I usually just half to shut it down and power back > >up. I have tried resetting the EDP by holding down the Parameters button but > >that doesn't help. > > > >It's really strange all this started happening when I was trying to send > >midi CC commands from my Behringer FCB1010 through my MOTU Midi Timepiece > >II to my Eclipse to change programs up and down. All of my midi gear is > >routed through my Timepiece but it has been setup like this for almost half > >a year and no problems. Also my EDP is set to listen to notes and is on Midi > >CH#4 and my Eclipse is on Midi CH#5. Are these errors I'm receiving just a > >coincidence or do they have a direct correlation to the CC commands I sent > >to my Eclipse. Any ideas? > > If they are really on different channels it should be ok, but your >problem > smells a little like a midi loop to me. see if the EDP works when > disconnected from the midi stuff and debug from there. > > kim > > > > ______________________________________________________________________ > Kim Flint | Looper's Delight > kflint@loopers-delight.com | http://www.loopers-delight.com > >