Support |
High frequencies clip easier on the EDP. Turn the input gain down until the distortion goes away. Changing the resistors on the input will only change the position of the knop required to get the proper signal to the edp. If you turn your input knob down, it can reduce the input signal to an appropriate level. Resistor change is not necessary, but it may make you feel better about the knob position. You can also reposition the know on the potentiometer shaft to point however you want, if that matters to you. This input control is just a voltage divider, absolute position should not matter as long as you have the range you need for your inputs. bret --- Louie Angulo <laab2000us@yahoo.com> wrote: > sorry i meant increasing the tolerance of the input or > decreasing the sensitivity > I am curious how far do you have the input normally > set? i have it at about 11 o´clock and it still clips. > I am running a roland preamp into it but i also own a > boomerang which hardly ever clips.It is specially > sensitive with bright tones. > cheers > lou > > > that doesn't make sense. if you are clipping the > > input of the EDP, you want > > less gain on the EDP input, not more. Turn down the > > EDP input knob to where > > it doesn't clip. Or use normal line level outs from > > the guitar stuff. If > > you are running the loop output back into the same > > guitar amp you are > > otherwise playing through, expect it to sound like > > mush anyway. You are > > much better off running the loops through a clean PA > > type system. > > kim > > > > > > > ______________________________________________________________________ > > Kim Flint | Looper's Delight > > kflint@loopers-delight.com | > > http://www.loopers-delight.com > > > > > ===== > > > __________________________________________________ > Do You Yahoo!? > Yahoo! Finance - Get real-time stock quotes > http://finance.yahoo.com > __________________________________________________ Do You Yahoo!? Yahoo! Health - Feel better, live better http://health.yahoo.com