Looper's Delight Archive Top (Search)
Date Index
Thread Index
Author Index
Looper's Delight Home
Mailing List Info
[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

Re: Loopers-Delight-d Digest V02 #623

> Just got the FCB1010 and after assigning ExpA to Feedback control it
>  only works over a very short range of the pedal- I tried reversing the
>  Min and Max values to no avail- any ideas? Also- has anyone created a
>  sysex dump of their FCB1010 to control EDP and/or Repeater they could
>  send me? Thanks- 
>

Hi Cliff
a guy called Bruce had the exact same problem, 
Get you sorted in about 5mins. :-)

andy



OK Bruce, sounds like you're pedals need recalibrating.
So here's the recalibration procedure, it's not on the Behringer site.

I found it best to use "not quite" the full range of the pedal when
calibrating, as following the instructions exactly
can  give you a slightly reduced range. 


Behringer FCB1010 POST/recalibration HOWTO
The original text is from Behringer support, posted to uk.music.guitar on 
11th Dec 2001. I (Mike) have edited it a bit for clarity. 
Keep footswitches 1 and 3 pressed while switching on the unit (This bit 
you 
can't do standing up!). Release the switches when the display blanks. The 
LEDs on the footswitches, the ones on the display and each segment of the 
two 
numeric displays will turn on and off in sequence. 
Wait untill all footswitch LEDs are on. Depress all footswitches one at a 
time, including UP and DOWN, untill all LEDs are off. 
Wait untill relay switch test is finished. (There will be a couple of 
mechanical clicks, and the display will end up reading "F1" (at least, it 
did 
on mine)). [Also, if you have connected a MIDI cable between the MIDI in 
and 
out, the display will show "A1" before this, meaning the midi ports work 
correctly.] 
Press DOWN once. 
Adjust the left expression pedal (A) to the lowest value. Once adjusted 
press 
UP. 
Adjust the left expression pedal (A) to the highest value. Once adjusted 
press UP. 
Adjust the right expression pedal (B) to the lowest value. Once adjusted 
press UP. 
Adjust the right expression pedal (B) to the highest value. Once adjusted 
press UP. 
Select a patch which has both pedals set to their full range, and check 
the 
expression pedals now send 0-127 (0x00-0x7F)