Re: Roland FC-200/Behringer woes

["Clifford Novey" <om@Om-Studios.com>]

You select the preset you want to program- then once you get into program
mode any footswitch which is lit means it is active for that particular
preset- each footswitch has a small label which shows PC or CC- I think
pedals 6 and 7 are for CC messages- so you press and hold to turn on/off-
then you press any lit switch to edit its value (it begins to blink)- press
bank up- enter the cc# you want and so fourth- anyway I was stumped the 
same
way at first- I hope this helps-
Cliff

----- Original Message -----
From: "Stuart Wyatt" <stuart@solostring.com>
To: <Loopers-Delight@loopers-delight.com>
Sent: Monday, September 30, 2002 1:34 PM
Subject: Re: Roland FC-200/Behringer woes


>
> On Monday, September 30, 2002, at 05:41 PM, Mark Sottilaro wrote:
>
> > The manual is confusing, but stick with it.  Once you get the knack,
> > it's pretty easy and it's something you can program using only your
> > feet.  I think what tripped me up was the manual calls the buttons
> > "switches" and the "switch output" (for Behringer guitar amps) both
> > switches.  You basically ignore the first step by pressing "up/enter"
> > then start programming.
>
> I managed to have limited success with with the 1010 today, but one
> thing that is throwing me is sending CC instead of PC messages. I need
> to send the Repeater a CC message of 108 (erase loop), either by a
> separate footswitch or by a button on the Behringer... I cant seem to
> fathom it. The switches all adhere to PC format.... any ideas? Is this
> possible?
>
> Re: the FC200 - one thing to take note is that it only transmits PC
> messages up to PC99 - in other words, the most interesting aspects of
> the Repeater are denied.....
>
>
> >
> > Mark Sottilaro
> --
> Stuart Wyatt - Solo String Project
> http://www.solostring.com
> stuart@solostring.com
>
>
>