RE: Repeater owners question

["Paul Weissman" <paul-mailinglists@nioterra.com>]

i asked a while ago about sharing this utility... the problem then was that
it was written in perl and required perl to be installed on the system.  
the
only solution i could find for compiling perl into an exe cost $100... and
it didn't seem like there was enough interest in people being able to split
that cost.

i'm now actively writing vst plugs so it would be no problem to do an
executable version.  however, there are two new problems a) time, i am at 
an
all time low of this particular lovely resource, and b) i only have one
repeater left and it will probably be leaving soon, so i'll have no way to
test the thing out.  also, with a few small additions the tool could be
quite powerful (like adding small options in the way the exports are done)
so i would be very tempted to work on it for a little while longer to 
polish
it off, which goes back to that time thing again.  i'd be very hesitant to
offer this for some small s$$$ (cause it seems like it should've been in 
the
damn repeater to begin with), but it would definitely add incentive to
finishing it off.  any thoughts?

paul



> -----Original Message-----
> From: Neil Goldstein [mailto:ngold@attbi.com]
> Sent: Monday, March 03, 2003 5:35 PM
> To: Loopers-Delight@loopers-delight.com
> Subject: RE: Repeater owners question
>
>
> Could you share this program?
>
> -----Original Message-----
> From: Paul Weissman [mailto:paul-mailinglists@nioterra.com]
> Sent: Monday, March 03, 2003 5:15 PM
> To: Loopers-Delight@loopers-delight.com
> Subject: RE: Repeater owners question
>
>
> > "trim cut" is supposed to do this.
>
> errr... it doesn't.  definitely one of the most frustrating aspects of
> the
> repeater for those who also do work with computers.  there is NO
> automatic
> way to get files into or out of the repeater.
>
> i actually wrote a small program to export files from 'repeater format'
> .wavs to regular waves and vice versa (in a limited way).  it was the
> only
> solution that seemed to work.
>
>
>
>
>
> > -----Original Message-----
> > From: Jim Palmer [mailto:jimp@pobox.com]
> > Sent: Monday, March 03, 2003 12:39 PM
> > To: Loopers-Delight@loopers-delight.com
> > Subject: RE: Repeater owners question
> >
> >
> > i used the wrong word.
> > "trim cut" is supposed to do this.
> > see page 33 of the repeater manual.
> > i haven't done this personally, so i don't
> > know how well it works...
> >
> >
> > >
> > > What do you mean? If you mean remix, they are still in the
> > > same loop format. There is a proprietary header file and the
> > > raw WAV file on the Card.
> > >
> > >
> >
> >
>
>