Re: Question about Line6 DL-4

["Miko Biffle" <biffoz@arczip.com>]

It works on every knob available. I use it to change pre-delay time,
add/remove feedback from the pre-delay, change the modulation, adjust the
mix of the pre-delay as well as the mix of the loop. It's totally awesome.
Just turn the knobs to the min/max settings and use the pedal!

The pre-delay is just that. A delay to use before the looper so it gets
recorded into the loop.

-Miko

----- Original Message -----
From: "| SquidLoop |" <squidloop@thetentacle.org>
To: <Loopers-Delight@loopers-delight.com>
Sent: Tuesday, September 02, 2003 8:53 AM
Subject: RE: Question about Line6 DL-4


> It works in Loop Mode but only affects the pre-delay.
>
> :::-----Original Message-----
> :::From: LeonD [mailto:ld60@rcn.com]
> :::Sent: Tuesday, September 02, 2003 8:03 AM
> :::To: Loopers-Delight@loopers-delight.com
> :::Subject: Re: Question about Line6 DL-4
> :::
> :::And without an expression pedal, the only way to turn the pre echo on
> or
> :::off
> :::is to manually turn the echo's volume up or down.
> :::
> :::I don't know if the expression pedal works in loop mode.  Anyone?
> :::
> :::LeonD
> :::
> :::
> :::
> :::> Well, if I read it right, the pre-delay of up to 800 ms will allow
> for
> :::a
> :::> delay of your dry signal BEFORE it is received by the delay. I
> don't
> :::> believe you have access to it other than as a pre-delay. Other
> :::> time-based effects have this feature and all of them work this way.
> :::>
> :::> It does seem a bit confusing. I've never had use for it on the DL4,
> so
> :::> I'm not completely sure if it functions this way. Try it!
> :::
> :::
> :::
>
>
>