Support
Looper's Delight
|
Support |
|
|
I read an interview with Jimi Hendrix's tech guy, who had to re-wire the middle eq pot on his marshall stack, because Hendrix preferred his sound with the center scooped, but wouldn't play unless all the knobs were set at full... bIz -----Original Message----- From: Kim Flint [mailto:kflint@loopers-delight.com] Sent: Monday, September 29, 2003 1:57 PM To: Loopers-Delight@loopers-delight.com Subject: Re: EDP IN/OUT Mod At 02:43 PM 9/28/2003, Laurent Brondel wrote: >i own 2 EDPs, one oberheim-branded and one gibson-branded. even though >i >changed the IN/OUT capacitors I think you mean resistors.... >on the oberheim -as per kim's EDP pages recommendation-, i am still not >getting the same IN/OUT level as on the gibson. is there a mod to render >them similar? that would be very handy for quick visual setups. is your concern just about the knob positions? Why not just pull the knobs off one and place them back rotated a little so they match in level when the knob indicator is in the same spot? Otherwise, the circuit inside is pretty much the same. Maybe the pots have a different taper or something, I guess that could make a difference. The only other possibility is with the limiter in the newer units. If you have the level turned up too high, you will be hitting the limiter in one and not the other, and that could obviously make them different. If that is the case though, you just have the level turned up too far.... kim ______________________________________________________________________ Kim Flint | Looper's Delight kflint@loopers-delight.com | http://www.loopers-delight.com