RE: FCB1010 EDP MIDI thru problem?

["L. Angulo" <labalou2000@yahoo.com>]

by the way Glenn i had a similar problem when i had
the loop IIIv. loopIV seems to have solved the problem
for me.
Cheers



L.a
> Yes, it does pass the MIDI in signal through an
> active circuit as stated in
> the midi spec you copied below. If there wasn't an
> active circuit involved
> then it would be just like connecting a patch cable
> from input to thru
> (passive) which isn't the case.
> 
> The midi in signal is being buffered and sent out
> (thru) an opto isolator.
> 
> I never said I think the EDP is the cause, the
> problem is showing up as the
> EDP doing funny things and not responding.
> 
> I have checked all my cables, and all the midi
> devices in my rack which all
> have true "midi thru" connections. The problem
> happens regardless of which
> device midi thru I use. (tried it on 5 different
> midi devices) 
> 
> What is "midiox" ?? some type of midi monitor
> program? Does this run on a
> PC? If so, where can I get a copy... that would be a
> big help with trouble
> shooting this problem!
> 
> Glenn
> 
> 
> 
> -----Original Message-----
> From: Claude Voit [mailto:c.voit@vtx.ch] 
> Sent: Friday, January 23, 2004 12:31 PM
> To: Loopers-Delight@loopers-delight.com
> Subject: Re: FCB1010 EDP MIDI thru problem?
> 
> thru is thru it doesnt hit any internal cicuit
> from the official midi spec
> """"""""""""""""""""""""""""""""""""""""
> A "MIDI THRU" output may be provided if needed,
> which provides a direct copy
> of data coming in MIDI IN.  For very long chain
> lengths (more than three
> instruments), higher-speed optoisolators must be
> used to avoid additive
> rise/fall time errors which affect pulse width duty
> cycle.
> """"""""""""""""""""""
> 
> so the question is why do you think its the EDP ?
> 
> Check your cables
> Check your cables
> Check your midi fx does it have a midi out with thru
> capabilities or is it a
> "real" thru
> read EDP's midi thru and analize it with midiOx
> 
> its not the EDP
> 
> good luck
> 
> Claude
> 
> 
> > Hey folks...
> >
> > Just searched through the archives to see if I'm
> the only one who's
> > experienced this odd problem... apparently I am
> (yikes!!)
> >
> > I'm using the Behringer FCB1010 to control a pair
> of EDP's using midi note
> > on/off info.
> > If I connect the FCB1010 midi out directly into
> the EDP's midi in,
> > everything works fine...
> > But if the midi out from the FCB1010 first goes
> into one of the midi
> devices
> > (multi fx) in my rack, then I use the device's
> midi thru to feed the EDP,
> > the EDP doesn't respond and will sometimes do
> strange things like go into
> > parameter mode when I try and send a note
> message...
> >
> > I can't believe this is happening! And it's
> driving me crazy... help!!!
> >
> > Any ideas? Anyone? Please??
> >
> > Glenn Fin
> >
> >
> 


=====
www.luis-angulo.com

__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free web site building tool. Try it!
http://webhosting.yahoo.com/ps/sb/