Support
Looper's Delight
|
Support |
|
|
Hey Kris, Can u tell me how to quickly dump all the presets from the master EDP to the slave? thanx Luis --- Kris Hartung <khartung@cableone.net> wrote: > I use two EDPs in true stereo. We've had this > discussion before on the list, > and playing in stereo is less important to some than > others, but for me it > is essential to my "current" sound, given all the > stereo imaging I use with > my laptop VST effects. I'm also an addict of lush > stereo chorus and stereo > delay where the left side is lightly longer than the > right. > > In any event, I have had no troubles with my setup, > except initially when > trying to figure out how to get the two EDPs to sync > up and prevent signal > drift. When you get to that point, send me an email > and I'll send you the > list of parameters. > > I run from my into my Boss VF1 from my guitar, out > of the VF1 in stereo, > into my laptop in stereo, out of the laptop in > stereo, into my Mackie mixer > board (two channels panned left and right), and then > I run out of the > mixer's BUSS 1 into the input of one EDP, and out of > BUSS 2 into the input > of the other EDP....then out of the two EDPs into > two channels of the board, > panned left and right. This way, when multiple > people or instruments are > plugged into my board, I can simply press the buss > 1/2 button on their > channel and loop them in my mix. I run an Lexicon > LXP1 in my mixer's AUX 1 > channel, and back into a stereo channel of the board > for a nice reverb on > everything. > > I think the results are especially noticeable and > fun when you are recording > off the board....then the stereo imaging really pops > out, if you are using > effects that to tricks in stereo. > > Kris > > ----- Original Message ----- > From: "Dennis Montgomery" <morpheus@speakeasy.net> > To: <Loopers-Delight@loopers-delight.com> > Sent: Thursday, January 12, 2006 6:58 PM > Subject: 2nd EDP+ for stereo > > > > Hi all, I currently take the output from my lone > EDP+ and send it through > > an Alesis Microverb III to get some pseudo-stereo > separation. I'm > > considering adding a 2nd EDP+ so I can process my > loops in true stereo. I > > was wondering if any players who have taken this > step can comment on their > > experience of using a 2 EDP+ stereo system? Did > it really make a > > difference in your playing fun? Any technical > problems? etc... > > > > Dennis > > > > > > > www.luis-angulo.com __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com