sorry mate!
the jacks are 2 prong
the left one (output) has a purple wire that goes from the ring connector to earth on the back cover and a blue wire that goes from the tip connector to pin 6 on the switch
the right one (input) has a purple wire that goes from the ring connector to the board (solder joint immediately left of the fixing screw top right) and a yellow wire that goes from the tip connector to pin 5 on the switch
pin 1 on the switch (green) goes to the bottom circuit board
pin 2 (yellow) goes to top circuit board (top right)
pin 3 (brown) goes to top circuit board (as seen in pic)
pin 4 (black) goes to earth on the casing near the on/off switch
pin 5 (yellow) goes to input tip
pin 6 (blue) goes to output tip
pin 7 (empty)
pin 8 (yellow) goes to pin 9
switch pins..
1 2 3
4 5 6
7 8 9
as you look at it when it's bottom left
hope that helps!
sim
On Thu, Oct 2, 2008 at 12:01 AM,
<legion@helpwantedproductions.com> wrote:
thank you VERY much.
One quick question: at the jacks only two prong?
With the board facing you (like in the pictures) what color cables are
going to the left jack? I can see ablue one but can't make out the other
color or where it is going?
thanks!
D_
