Re: EDP message

[andy butler <akbutler@tiscali.co.uk>]

That's one of three error messages that you may see
when the edp crashes.

Just reboot and it'll be fine.

If you can get the error where the EDP looks ok,
but cycles through the whole memory of the current loop
until it finds it's way back to playing the audio that it ought
to then you get a certificate.
I never figured it, but something to do with Nextlooping away
from a loop before it's sorted itself out after Mult and Reverse.

andy

Stephen Scott wrote:
> I just had 'dEAdr' appear on the display of my EDP when going into 
>nextloop.  Prev loop kept repeating, but all front panel buttons and FCB 
>presses were inoperative.  Everything *seems* OK after a power down/up.
> 
> Never seen this message before, no mention of it in the manual. Only 
>thing I'd done differently was to change SYNC to Out (previously Off), 
>about 45 mins of use ago.
> 
> Any ideas?
> 
> Stephen
> 
> 
> 
> 
>       
> 
>