Re: Newbie EDP Question

[Jeff Shirkey <jcshirke@frontier.com>]

> Sounds a little like a hardware problem... Im afraid... maybe a unit  
> reset would help?
> (hold down parameter button while you boot up)

Would a unit reset be a good idea anyway, since I got the unit used?  
It was advertised as being in mint condition, and cosmetically it is.  
But maybe a reset would be a good idea to clear out any settings that  
the prior owner made that I'm not aware of?

Or, let's put it differently. Is there any drawback to doing a reset?

I think I sorted out my problem, though. It might have been a feedback  
knob issue. After I made sure the Parameter/Record setting was LOP, I  
didn't set the feedback knob to 100%. I left it where it had been  
previously, which was maybe 60% or so. Now my first loop seems to  
maintain its volume and not diminish at all.

Here's the thing, though. I have another EDP just like this one, and  
the feedback knob on it is not set to 100%, but the loop volume  
remains constant.

Maybe I should do factory resets on both units and start from scratch?

Thanks,

Jeff