Re: flexible amplification to loop el. guitars

["Mike Biffle" <Mbiffle@svg.com>]

>> I personally use a GT-5 with speaker simulation, but when I WAS using 
>an amp, I found the HK Red Box to be a good sounding, cheap, small and 
>simple solution. You can either take the preamp out, or put it between 
>the power amp speaker output and the speaker. The new ones don't use 
>batteries either... Then there's the good old Sans Amp Classic and GT2.

>-Miko

> hmm... if you imitate the nonlinearities of an amp between the power amp 
>speaker output and the speaker instead of using the amp you still get the 
>same problem...

I'm talking between the pwr amp and speakers of the **guitar** amp... 
(allows you to get all the nuance of the pre-power stages of the amp) 
*that* gets the signal out to the board where you can then add time domain 
and full-range stuff which then goes on to the pa/full-range speaker 
system. 

-Miko