Re: A FIX! (was Re: Behringer FCB1010 HELP!)

["Michael LaMeyer" <m.lameyer@verizon.net>]

THANK YOU!  attempting calibration now ...

i've found that i've needed to program pc messages on the
repeater one number higher than listed in the repeater midi
implementation chart.  i've been wondering about typos, because
the procedure above was not necessary for the Record pc message,
which i've got set to pc4 on the 1010, as it is in the chart.
all my other pc messages coming from the 1010 are 'repeater midi
implementation chart value' +1.

mike

----- Original Message -----
From: "Mark Sottilaro" <sine@zerocrossing.net>
To: <Loopers-Delight@loopers-delight.com>
Cc: "Michael LaMeyer" <m.lameyer@verizon.net>
Sent: Sunday, March 17, 2002 2:43 PM
Subject: A FIX! (was Re: Behringer FCB1010 HELP!)


> OK, I'm wrong!  The FCB1010 DOES in fact control the output
level of the
> Repeater via CC (CC#110 controls channels 1&2, CC#111 3&4)
>
> Why wasn't mine (or Michael LaMeyer's) working?
>
> They were WAY out of calibration!  WAY OUT!  Poking around the
web I
> came across this little nugget:
>
> http://www.altrion.org/fcb1010/post.html
>
> and followed a total calibration procedure.  Woop, there it
is.  After
> following this simple procedure, my FCB1010 now works fine...
for
> sending CC from the expression pedals.  Can't confirm whether
the other
> issue about PC numbers not all working, but I also found a
post
> somewhere that states the FCB1010 spits out a PC+1 message,
which could
> be the source of many of the problems with this badboy.
>
> On the upside, I've found that of all (MidiWizard and Yamaha)
the MIDI
> controllers I've purchased, this one is by far the best for
controlling
> the Repeater.  Also the cheapest.
>
> Now, I just have to make EVEN more room on my floor to deal
with it!
> YIPE!
>
> Mark