At 4:31 PM -0500 3/17/02, Michael LaMeyer wrote: >THANK YOU! attempting calibration now ... > >i've found that i've needed to program pc messages on the repeater >one number higher than listed in the repeater midi implementation >chart. I've confirmed this, though I've found that Loop Multiply can be triggered by either Program Change 0 or 1. >i've been wondering about typos, because the procedure above was not >necessary for the Record pc message, which i've got set to pc4 on >the 1010, as it is in the chart. This is odd, because Record IS Program Change 4, though it is listed as 3 in the chart. -- ______________________________________________________________ Richard Zvonar, PhD (818) 788-2202 http://www.zvonar.com http://RZCybernetics.com http://www.cybmotion.com/aliaszone http://www.live365.com/cgi-bin/directory.cgi?autostart=rz