EDP MultiIncrease

[John Metzler <jarofjam@mac.com>]

Hi everyone.
        I haven't dug too deep into Loop IV, in fact , I hardly scratched 
the 
surface of Loop III before upgrading.  But if I only upgraded after 
mastery then I'd still be trying to figure out what all the extra 
buttons on my high school calculator are for instead of sending emails 
from my Mac.
        So here's my question.  It confuses me when I want to multiply my 
loop 
4 cycles by using the MultiIncrease and after the second press of 
Multiply it starts running numbers.  What's going on?  If I continue 
just tapping out the Multiplys it works,  I see the C<number> but I 
want to understand what is happening.  What does the manual mean by 
"The Echoplex begins Rounding off the multiply, just as it always has." 
  By the way, I have Quantize = CYC.

---John M.