|
Well, I guess I had the loop length as just one cycle...so sending it once every cycle makes sense.
If you find the info on sending a Midi Note for every beat, that would be extremely helpful. Thanks for the alternate method as well!
D
In a message dated 04/14/08 13:44:41 Eastern Daylight Time, akbutler@tiscali.co.uk writes:
afaik you have the settings correct,
and that's what the beatsync does.
(except that it actual sends a click once per cycle rather than once per loop)
the EDP can output a Midi Note for every beat,
I'll look up the details if that would help.
Other way to do it:-
(there usually is one)
1) set 8th/cycle to 2 (for quarter notes)
2) set your tempo
3) Record your loop rather carefully to get the right time sig.
andy butler
Donearlsto wrote:
> Hello all,
> According to the manual, after setting a tempo via SetTempo, a signal is
> sent out of the Beat Sync Jack that can act as a "click track." When I
> do this, however, all I get is a click at the start of each loop cycle,
> not for each beat. Is there a way to send the "click" for each quarter,
> rather than only at the beginning of each cycle? Perhaps I have a
> setting incorrect? Any help is appreciated.
>
> Donovan Stokes
> ------------------------------------------------------------------------
> Get the MapQuest Toolbar
> <http://www.mapquest.com/toolbar?NCID=mpqmap00030000000003>, Maps,
> Traffic, Directions & More!
|