Re: Help! FCB1010 is Changing EDP parameters against my will!

["Per Boysen" <perboysen@gmail.com>]

> Jack Schultz wrote:
>>
>> Hi All,
>>
>>  I'm relatively new here, but I was hoping someone could help me out 
>with
>> my problem.  I programed  my new Behringer FCB1010 to send virtual 
>button,
>> Direct MIDI and continuous controller commands to my Echoplex, but when 
>I
>> use any of the virtual button, or Direct MIDI it resets the parameter
>> settings. For Example,  if I play with Quantize =CYC, Overdub=SUS, and
>> Insert=REV, then after one button press on the FCB1010 it reverts to
>> Quantize=OFF, Overdub=EOG, and Insert=rhr.  No matter what my settings 
>were,
>> they alwasys end up the latter. Using the continuous controller to 
>control
>> feed back does not do this, however.
>> I tried repogramming the buttons, but the same thing keeps happening.
>>  Does anyone know what causes this
>
> fcb must be sending PC commands
>
> and how to make it not happen?

On Mon, Jan 19, 2009 at 3:45 PM, andy butler <akbutler@tiscali.co.uk> 
wrote:
> de-activate the PC commands from the fcb


If that should not help (i.e. the FCB is spitting out events by
itself, as mine did) you can fix the problem by making sure that your
gear is not listening to anything except the events you have assigned
to do something.

Greetings from Sweden

Per Boysen
www.boysen.se
www.perboysen.com