Re: FCB1010 UnO SooperLooper question

[andy butler <akbutler@tiscali.co.uk>]

hi Loren,
probably worth asking Xavier about this.

..but first check the programming of the Record button
(unless you're ending record with some other button).
Most likely there's a error in the programming of the exp peds.

andy

ps. looking at the Uno manual :-

5. CC “MOMENTARY” TOGGLING A special case of “momentary toggling’ is 
implemented : in this mode, a CC message with programmed value is sent 
when clicking a footswitch, and the same CC message , this time with value 
0, is sent when releasing the footswitch. This mode is enabled by setting 
the alternate CC value to 1, and disabling the CC toggling.  

so with the edp, using ControlSource=CC might allow
a few useful extra functions


Loren Claypool wrote:
> I received an FCB1010 with UnO upgrade today and tested it this evening 
> with SooperLooper running inside of Live. I had an issue that I suspect 
> is something I'm missing in either the FCB1010 setup or my SooperLooper 
> MIDI bindings and am hoping for some input from the FBC1010 experienced 
> folks.
> 
> I have Direct Select Off, Switch Mode momentary, PC values 1-10 for the 
> switches, one expression pedal at CC7 and the other CC27. Everything 
> works great except when I finish recording a loop the two expression 
> pedals swap settings. For example, if the left pedal is controlling 
> selected feedback and the right pedal is controlling selected volume, 
> after recording the left pedal is now volume and the right pedal is 
> feedback. If I change loops the pedals revert back and all is well until 
> I record the next loop. Thoughts?
> 
> Thanks,
> 
> Loren Claypool
> genre-indifferent instrumental guitar music
> www.lorenclaypool.com and links from there
> 
> 
> 
>