Yes, I think I included it in one of the last scripts but to
wait for the start of the last subcycle, one way is:
Variable targetSubcycle subcycleCount - 1
Wait until subcycle targetSubcycle
On Jan 7, 2011, at 10:24 AM, Simeon Harris wrote:
the system variable "subcyclecount" exists. can this be used?
On Fri, Jan 7, 2011 at 4:06 PM, Simeon Harris <firstname.lastname@example.org>
fabio - you said -
but in the manual it says trimend will trim from the current frame to the end. how do you get it to trim from the last 8th or 16th to the end?
Did you try the "TRIM" commands ?
You can trim start point and end point according to your 8th-16th or whatever per cycle setting.