Support |
Kim Thanks for the quick response. The MuteMode=continuous didn't solve my problem completely - in that I still can't get the action of a MUTE press to delay to the end of the cycle ( which I had previously) - not immediate - which the manual indicates is the only way. I also have a another question I use my EDP along with my DAT in my home studio. I would love to have this setup in stereo. Could I sync the two machines (special cable??), controlling each with separate foot switches? Is the EDP foot controller of any benefit in controlling two EDP's. ( vs two EV5's for each) For my needs, two EV5 foot switches are all I need for my one EDP. Thanks in advance Gerry P manda@norlink.net -----Original Message----- From: Kim Flint <kflint@chromatic.com> To: Loopers-Delight@annihilist.com <Loopers-Delight@annihilist.com> Date: Thursday, December 03, 1998 4:08 AM Subject: Re: Delaying MUTE action? >turn quantize parameter on, MuteMode=continuous. > >kim > > >At 09:15 PM 12/2/98 -0000, you wrote: >>I had my EDP set up so that when I hit MUTE, the loop would continue playing >>until the end of the current cycle and then mute - and hitting UNDO, started >>the loop from the start - immediately. >> >>Last night I was playing with some EDP settings and now I can't get back to >>the above. Not only that, but the manual says that MUTE always acts >>immediately??? >> >>Any suggestions would be appreciated. >> >>Gerry P >>manda@norlink.net >> >> >> >> >________________________________________________________ >Kim Flint, MTS 408-752-9284 >ATI Research kflint@chromatic.com > >